PL6700-T42-W910F PL6700-T42-WN02 PL6700-T42-WN02F PL6700-T42-WN10F Pro-face Front Overlay Touch Glass

Be sure to follow the instructions given below to ensure the safe use of the PL6700-T42-W910F PL6700-T42-WN02 PL6700-T42-WN02F PL6700-T42-WN10F Protective Film Touch Glass PL.
Before opening the PL6700-T42-W910F PL6700-T42-WN02 PL6700-T42-WN02F PL6700-T42-WN10F Touch Panel Front Overlay PL's protective cover, be sure to turn the unit's power OFF. This is because the PL's internal parts carry high voltages.
To avoid fires or electrical hazards, do not modify the product in any way.
Read and understand Chapter 4 Installation and Wiring thoroughly in order to select an appropriate installation location for the PL.
Before either plugging in or unplugging a board or interface connector, be sure to turn the PL's power OFF.
To avoid the possibility of electrical shock, be sure to connect the power cord to the PL before connecting it to the main power supply.
To avoid fires or electrical shocks, do not use voltages beyond the specified range.
To prevent a possible explosion, do not install the PL6700-T42-W910F PL6700-T42-WN02 PL6700-T42-WN02F PL6700-T42-WN10F Touch Membrane Front Overlay PL in areas containing flammable gases.
Before replacing the 100V unit's backlight, be sure to turn the unit's power OFF to avoid electrical shocks. (Note: Do NOT attempt to replace the 24V unit's backlight)
Do not create touch panel switches that are used to either control or ensure the safety of equipment and personnel. Mechanical switches, such as an emergency stop switch, a deadman (two-handed) start switch, etc., must be installed and operated via a separate system.
If metal particles, water or other types of liquids contact any of the PL6700-T42-W910F PL6700-T42-WN02 PL6700-T42-WN02F PL6700-T42-WN10F Protective Film Touch Screen Panel PL's internal parts, immediately turn the unit's power OFF, unplug the power cord, and contact either your dealer or Digital Electronics Corporation.