IDEC FT1A-M14SA-B HMI Touch Screen Tablet Repair

Warning

1. Prevent the FT1A-M14SA-B Touch Screen Panel from falling while moving or transporting, otherwise damage or malfunction will result.
2. Use of the FT1A-M14SA-B Touch Screen Film in high-temperature or high-humidity environments, or in locations where it is exposed to condensation, corrosive gas or large shock loads can create the risk of electrocution and fire.
3. When more than one button is pressed at the same time, due to the detection characteristics of an analog type FT1A-M14SA-B HMI Touch Glass, only the gravity center of the pressed area is sensed and the unit assumes that only one button is pressed. Thus, don't operate the FT1A 3.8IN PLC+HMI by pressing more than one button simultaneously.
4. Do not push hard or scratch the FT1A-M14SA-B Touch Membrane protection sheet with a hard object such as a tool, because they are damaged easily.
5. Although the screen will not be visible if the backlight burns out, the touch panel will remain functional. Incorrect touch panel operation will occur when operating the FT1A-M14SA-B HMI Panel Glass when the backlight appears to be turned off but is actually burnt out. Because such an erroneous operation could result in damage, the touch panel should not be used after the backlight has burned out.
6. The touch panel of the IDEC FT1A is made of glass and will break if exposed to excessive shock. Take due care when handling it.
7. Do not install the FT1A-M14SA-B Touch Digitizer Glass in areas subjected to strong ultraviolet rays, since ultraviolet rays may impair the quality of the LCD.