IDEC HG3G-8JT22MF-B Overlay Film Touch Membrane Repair

Order each part separately is available

Maintenance and Inspection of HG3G-8JT22MF-B Protective Film Touch Screen Display

Maintain and inspect the IDEC HG3G-8JT22MF-B Touch Digitizer Glass Overlay Film periodically to ensure the best performance. Do not disassemble, repair, or modify the High Performance Series HG3G-8JT22MF-B Protective Film MMI Touch Glass during inspection. Wipe any stain off the display using a soft cloth slightly dampened with neutral detergent or alcoholic solvent. Do not use solvents such as thinner, ammonia, strong acid, and strong alkaline. Check the terminals and connectors to make sure of no loose screws, incomplete insertion or disconnected lines. Make sure that all mounting clips and screws are tightened sufficiently.If the mounting clips are loose, tighten the screw to the recommended tightening torque.

Adjusting the HG3G-8JT22MF-B Touch Panel Front Overlay

A gap may be caused in the operation accuracy of the touch panel by the secular distortion, etc. Readjust the touch panel when there is a gap in the operation of the touch panel.

Panel Cut-out Dimensions of HG3G-8JT22MF-B Touchscreen Front Overlay

Place the IDEC Terminal in a panel cut-out and fasten with the attached mounting clips. Do not tighten excessively, otherwise the HG3G-8JT22MF-B Overlay Film Touch Membrane may warp and cause wrinkle on the display, or impair the waterproof characteristics.

Note for operation

The screen becomes blank when the backlight is burnt out; however, the HG3G-8JT22MF-B Touch Panel Protective Film remains enabled. Incorrect touch panel operation will occur when operating the touch panel when the backlight appears to be turned off but is actually burnt out. Note that this erroneous operation may result in damage.